mlabel(1) mtools-3.9.1 (10Jun98) mlabel(1)
Name
mlabel - make an MSDOS volume label
Note
This manpage has been automatically generated from mtools's
texinfo documentation. However, this process is only
approximative, and some items, such as crossreferences,
footnotes and indices are lost in this translation process.
Indeed, this items have no appropriate representation in the
manpage format. Moreover, only the items specific to each
command have been translated, and the general information
about mtools has been dropped in the manpage version. Thus
I strongly advise you to use the original texinfo doc.
* To generate a printable copy from the texinfo doc, run
the following commands:
./configure; make dvi; dvips mtools.dvi
* To generate a html copy, run:
./configure; make html
A premade html can be found at:
`http://www.tux.org/pub/knaff/mtools'
* To generate an info copy (browsable using emacs' info
mode), run:
./configure; make info
The texinfo doc looks most pretty when printed or as html.
Indeed, in the info version certain examples are difficult
to read due to the quoting conventions used in info.
Description
The mlabel command adds a volume label to a disk. Its syntax
is: mlabel [-vcs] drive:[new_label]
Mlabel displays the current volume label, if present. If
new_label is not given, and if neither the c nor the s
options are set, it prompts the user for a new volume label.
To delete an existing volume label, press return at the
prompt.
Page 1 (printed 7/15/98)
mlabel(1) mtools-3.9.1 (10Jun98) mlabel(1)
Reasonable care is taken to create a valid MS-DOS volume
label. If an invalid label is specified, mlabel changes the
label (and displays the new label if the verbose mode is
set). Mlabel returns 0 on success or 1 on failure.
Mlabel supports the following options:
c Clears an existing label, without prompting the user
s Shows the existing label, without prompting the user.
See Also
Mtools' texinfo doc
Page 2 (printed 7/15/98)
