USLCOM(4) BSD Kernel Interfaces Manual USLCOM(4)NAME
uslcom — Silicon Laboratories CP2101, CP2102 and CP2103 USB to serial
bridge
SYNOPSIS
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
device uslcom
device ucom
Alternatively, to load the driver as a module at boot time, place the
following line in loader.conf(5):
uslcom_load="YES"
DESCRIPTION
The uslcom driver supports devices based on Silicon Laboratories CP2101,
CP2102 and CP2103 USB to serial bridges.
The following devices should work with the uslcom driver:
· Argussoft In-System Programmer
· Baltech card reader
· Burnside Telecom Desktop Mobile
· chip45.com Crumb128 module
· Enfora EDG1228 EDGE modem
· Helicomm IP-Link 1220-DVM
· Jablotron PC-60B
· Lipowsky Baby-JTAG
· Lipowsky Baby-LIN
· Lipowsky HARP-1
· Pololu USB to serial adapter
· Suunto USB to serial adapter
· Tracient RFID readers
· West Mountain Radio RIGblaster
· West Mountain Radio RIGtalk
SEE ALSOtty(4), ucom(4), usb(4)HISTORY
The uslcom device driver first appeared in OpenBSD 4.0 and was imported
into DragonFly 1.11.
AUTHORS
The uslcom driver was written by Jonathan Gray ⟨jsg@openbsd.org⟩.
CAVEATS
Setting hardware flow control is not tested.
Silicon Laboratories don't release any programming information on their
products.
BSD August 15, 2007 BSD