HCIATTACH(8) Linux System Administration HCIATTACH(8)NAMEhciattach - attach serial devices via UART HCI to BlueZ stack
SYNOPSIShciattach [-n] [-p] [-t timeout] tty type|id speed flow
DESCRIPTION
Hciattach is used to attach a serial UART to the Bluetooth stack as HCI
transport interface.
OPTIONS-n Don't detach from controlling terminal.
-p Print the PID when detaching.
-t timeout
Specify an initialization timeout. (Default is 5 seconds.)
tty This specifies the serial device to attach. A leading /dev can
be omitted. Examples: /dev/ttyS1 ttyS2
type|id
The type or id of the Bluetooth device that is to be attached,
i.e. vendor or other device specific identifier. Currently sup‐
ported types are
type description
any Unspecified HCI_UART interface, no vendor specific
options
ericsson
Ericsson based modules
digi Digianswer based cards
xircom Xircom PCMCIA cards: Credit Card Adapter and Real Port
Adapter
csr CSR Casira serial adapter or BrainBoxes serial dongle
(BL642)
bboxes BrainBoxes PCMCIA card (BL620)
swave Silicon Wave kits
bcsp Serial adapters using CSR chips with BCSP serial protocol
Supported IDs are (manufacturer id, product id)
0x0105, 0x080a
Xircom PCMCIA cards: Credit Card Adapter and Real Port
Adapter
0x0160, 0x0002
BrainBoxes PCMCIA card (BL620)
speed The speed specifies the UART speed to use. Baudrates higher than
115.200bps require vendor specific initializations that are not
implemented for all types of devices. In general the following
speeds are supported:
9600, 19200, 38400, 57600, 115200, 230400, 460800, 921600
Supported vendor devices are automatically initialised to their
respective best settings.
flow If the keyword flow is appended to the list of options then
hardware flow control is forced on the serial link ( CRTSCTS ).
All above mentioned device types have flow set by default. To
force no flow control use noflow instead.
AUTHORS
Written by Maxim Krasnyansky <maxk@qualcomm.com>
Manual page by Nils Faerber <nils@kernelconcepts.de>
BlueZ Jan 22 2002 HCIATTACH(8)